Sonifex HY-03 Automatic Analogue TBU

HY-03 Automatic Analogue TBU - (Free Standing)

The analogue HY-03 telephone hybrid is the replacement for the HY-02, which for many years has set the standard as an excellent value, high quality telephone hybrid..

The HY-03 retains many of the features of the HY-02 and adds some additional ones. Some of the features of the HY-03 include :

• Fully automatic - adapts to varying line conditions and has automatic signal limiting.
• Local and remote line hold switching - calls can be remotely switched through a mixing console.
• Momentary or permanent latching remotes can be enabled.
• Balanced mic/line input - 10k ohm balanced input selectable for 0dBu clean feed line, or microphone level with adjustable gain.
• Balanced output - 0dBu low impedance balanced output, with output gain adjustment.
• Mixed output - the output can be a mix of the caller and mic/line input signals for recording both sides of the telephone conversation.
• Integrated ring detector - automatic call answering after a pre-determined number of rings.
• Fitted with K-break disconnect detection as standard with an option for dial-tone disconnect using the optional HY-03DTD board. The HY-03DTD board can be configured to disconnect on recognizing the dial tone used in a specific country.
• Line limiter, bandpass filter and output noise gate with preset threshold providing low distortion crystal clear audio.
• 28dB typical line balance rejection.
• Built in power supply with switchable 115V, or 230V, mains input.
• BABT approval compliant with European PTT specifications.

For more information on the Sonifex HY-03 Automatic Analogue TBU, click here!

The Company agrees to repair or (at its discretion) replace Goods which are found to be defective (fair wear and tear excepted) and which are returned to the Company within the Warranty Term provided that each of the following are satisfied:

1. (i) notification of any defect is given to the Company immediately upon its becoming apparent to the Purchaser;
2. (ii) the Goods have only been operated under normal operating conditions and have only been subject to normal use (and in particular the Goods must have been correctly connected and must not have been subject to high voltage or to ionising radiation and must not have been used contrary to the Company's technical recommendations);
3. (iii) the Goods are returned to the Company's premises at the Purchaser's expense;
4. (iv) any Goods or parts of Goods replaced shall become the property of the Company;
5. (v) no work whatsoever (other than normal and proper maintenance) has been carried out to the Goods or any part of the Goods without the Company's prior written consent;
6. (vi) the defect has not arisen from a design made, furnished or specified by the Purchaser;
7. (vii) the Goods have been assembled or incorporated into other goods only in accordance with any instructions issued by the Company;
8. (viii) the defect has not arisen from a design modified by the Purchaser;
9. (ix) the defect has not arisen from an item manufactured by a person other than the Company. In respect of any item manufactured by a person other than the Company, the Purchaser shall only be entitled to the benefit of any warranty or guarantee provided by such manufacturer to the Company.